Craftsman recommends using SAE 30 motor oil or a similar high-quality detergent oil with an API service classification of SF to SJ for best performance. If you use oil with a different viscosity rating, for example 5W or 10W, the engine will consume more oil when temperatures exceed 40 degrees Fahrenheit.

.

Also to know is, what kind of oil goes in a tiller?

Small Tillers These models can be run on 5W-30 or 10W-30 synthetic oil at any air temperature. If you prefer a detergent oil use, select one with an API rating of SF, SG, SH or SJ and use 5W-30 or 10W-30 below 40 degrees Fahrenheit and SAE 30 above 40 degrees Fahrenheit.

Furthermore, what kind of gas does a tiller take? Your tiller will take regular unleaded gas, not an oil/gas mixture.

Just so, how much oil does a Craftsman tiller hold?

The engine oil capacity is 19 ounces. Use SAE 5W-30 or SAE 10W30 in temperatures below 40 (F) degrees.

What oil goes in a 4 stroke tiller?

Follow. You can use 10w/30 oil, but this is thinner than the SAE 30, and therefore flows more easily in cold weather. However, some experts say it is too thin and the SAE 30 lubricates better, being more viscose.

Related Question Answers

What kind of oil do I use for my Troy Bilt lawn mower?

Standard SAE-5W30 motor oil is safe for most Troy-Bilt lawn mowers and works in a wide range of temperatures.

How many quarts of oil does a Troy Bilt Bronco take?

Refill the engine with 1-1/2 quarts of new oil, then check the oil level with the dipstick.

How do I change the oil in my Tiller?

How to Change the Oil in a Husqvarna Tiller
  1. Place the tiller on level ground.
  2. Clean the area around the oil fill plug.
  3. Remove the plug.
  4. The oil should be to the point of almost overflowing, check owner's manual for approximate capacity.
  5. To remove the oil, remove the drain plug and tip the tiller forward.

How do you tune up a tiller?

Gas-Powered Tiller Tune-Ups
  1. Check the Spark Plug.
  2. Change the Oil.
  3. Change the Filters (Air, Gas, Oil)
  4. Grease the Moving Parts.
  5. Tighten the Wheels.
  6. Check Tire Pressure.
  7. Inspect and Adjust All Drive Belts.
  8. Inspect the Tines.